Expert Aluminium Window & Door Installation Services in Ghaziabad

To ensure consistency and quality, we follow a strict Standard Operating Procedure (SOP) for every project, big or small. Here is a detailed breakdown of our installation workflow:

Step 1: Pre-Installation Site Audit Before a single tool is unpacked, our site supervisor conducts a final audit. We verify the measurements taken during the consultation phase against the delivered frames. We check the sill levels and verticals of the structural opening. If there are any discrepancies in the building structure, we address them immediately with the client to avoid future issues.

Step 2: Surface Preparation & Cleaning A clean surface is essential for adhesion. We clear the opening of dust, debris, and loose plaster. For renovation projects, we carefully remove existing windows while minimizing damage to the surrounding plaster. We ensure the recess is ready to receive the new aluminium frame.

Step 3: Frame Fixing & Alignment This is the most critical phase. We place the frame into the opening using temporary wedges to hold it in position. Using laser levels, we adjust the frame until it is perfectly vertical and horizontal. Once aligned, we drill anchor holes at strategic points—typically 150mm from corners and at 450mm centers—and secure the frame with corrosion-resistant steel fasteners. We never compromise on the number of anchors, as this dictates the structural integrity.

Step 4: Waterproof Sealing (The Monsoon Shield) For homes in Ghaziabad and Noida, water seepage is a major concern. We employ a dual-sealing technique.

• Primary Seal: We apply a continuous bead of high-modulus neutral cure silicone sealant between the frame and the wall. This sealant is flexible enough to absorb structural movements without cracking.
• Secondary Protection: For larger gaps, we use polyurethane (PU) foam backer rods before sealing. This prevents water from penetrating the wall cavity, ensuring your interiors stay dry even during the heaviest torrential rains.

Step 5: Glass & Hardware Fitting Once the frame is anchored and sealed, we install the glass panes. We use EPDM (Ethylene Propylene Diene Monomer) rubber gaskets and weather strips to secure the glass, providing a cushioned fit that prevents breakage and ensures insulation. Finally, we install handles, locks, and rollers, testing each mechanism for smooth operation.

Step 6: Final Quality Check (QC) & Demo Before handing over the site, our supervisor performs a rigorous 10-point Quality Check. This includes checking for:

• Smooth sliding/swinging action.
• Proper locking engagement.
• Gaps in sealant application.
• Glass cleanliness. We then demonstrate the operation of the windows to the client, explaining how to use features like tilt-and-turn mechanisms or multi-point locks effectively.